#Loxone dmx dimmer serial number

The installation requires a suitable enclosure to ensure protection against contact, water and dust. The installation must be carried out by a qualified technician in accordance with all applicable regulations. When selected, you will be notified via System Status or the Mailer if the device is no longer available or goes offline.

#Loxone dmx dimmer serial number

Specifies the serial number of the device.įor Extensions: 'Auto' may only be used if only one Extension of this type is being used. The actuator channel number in Loxone Config must match the channel number on the device. A single actuator uses one DMX channel, while an RGB actuator uses 3 channels and an RGBW actuator 4 channels. When adding actuators, they are created with ascending channel numbers. Then select an actuator to add it to the DMX Extension.

To do this, first click on the DMX Extension, and then on Add DMX Device: Now the added RGBW Dimmers are ready for use and available in Loxone Config.Īctuators need to be added to control other DMX devices. To apply the changes, save the program in the Miniserver. Now select a dimmer, enter a name and select the actuator type, then click on Create device. The RGBW 24V Dimmer allows for easy control of RGBW LED lighting (such as the RGBW LED Spots or the RGBW LED Strips from our webshop). The search results at the bottom of the Loxone Config, will list all connected Loxone DMX Dimmers. To search for Loxone RGBW 24V Dimmer DMX, first click on the DMX Extension in Loxone Config, and then activate DMX Device Search. Note: The Loxone RGBW 24V Dimmer DMX is no longer available. The Extension starts after switching on the power supply, and the status LED will flash orange after a short time when the connection to the Miniserver is established. Control your colour lighting either manually via switches or your smartphone, or automatically via a presence detector. We recommend a maximum cable length of 500m/1640ft. This connection is crucial for reliable data transmission.ĭMX devices are daisy-chained, the last DMX device must be terminated with a 120 Ohm resistor.įor wiring, a wire pair of a Cat 5/6/7 cable is recommended, alternatively another twisted pair cable can be used. GND must be also be connected to the DMX devices, this can also be achieved by connecting the GND of the power supplies of the respective devices. The DMX Extension is installed on a DIN rail in a suitable enclosure.Ĭonnect the power supply, Link communication to the Miniserver and the DMX data lines. The values are scaled from 0.255.ĭatasheet DMX Extension Table of Contents Compatible devices can also be paired.Ī value of 0.100% can be output on each DMX channel. Various actuators are available in Loxone Config to integrate DMX devices. The DMX Extension is designed to integrate devices with DMX interface.